ADDENDUM TO MANUAL
------------------

BIOS updates are loaded onto the board using the AMIFLASH.COM
program. To use this program, the ROM shadow and cache must be
disabled or the FLASH ROM update utility will not function properly.

The board is shipped with the factory defaults set as follows:

Board in ISA addressing mode
SCSI Enabled
SCSI Interrupt = 10
SCSI Address range 200h - 25Fh
LAN Enabled
LAN Interrupt = 15
LAN Address range 600h - 61Fh
BIOS Address Space C8000h - CFFFFh

If the LAN settings are changed, then the program FIXNETID.EXE must
be run to update the LAN information stored in the configuration ROM
on the card. This NETID update program uses a FLASH ROM update utility
and requires that the ROM shadow and cache be disabled to function
properly.

The NETID update program is run by typing

FIXNETID <cr>

You will be prompted to press any key to continue. Hit a key and
the configuration ROM will automatically be updated. When the update
is finished, you will be prompted to hit a key for REBOOT. Press any
key and your system will REBOOT. You are now ready to run the LAN.

NOTE: This update utility only needs to be run if the LAN settings for
I/O port address, or interrupt level change.

All the Flash utility programs are located in the FLASH directory
on the floppy disk.

DISK FORMAT UTILITY
-------------------
Located in the SCSI directory is a file named SDISK.EXE. This file
can be used for low-level formatting of SCSI drives. The SCSI DOS
drivers must be loaded prior to starting SDISK.

SCSI BIOS OPERATION
-------------------

The SCSI BIOS is capable of supporting more than one Fast LAN/SCSI VLB card.
If using more than one Fast LAN/SCSI VLB card, disable the BIOS on the
second card. In ISA mode, this is accomplished by setting the BIOS address
jumpers (J10, J11 and J12) all high. In EISA mode, this is accomplished
by running the ECU and disabling the BIOS on the second card. By
disabling the second BIOS, 32KBytes of adapter ROM space is freed up.

The SCSI cards must still have different I/O Port, Interrupt and
Sequence number settings. In this configuration in a Novell Server
with the LAN enabled on the second card, the LAN driver for the
second card must be loaded as follows:

: LOAD INTEL596 DRIV=1 GLOB=8 PORT=x INT=x